Flexible DRL LED Night & Daytime Running Light Strip

Gradient Color:

 Night & Daytime Running Light Strip

Used for car exterior decoration lightAngel Eye Light, Daytime Running Lights, Turn Signal Lights, Eyebrow Lights, Rear Window Lights, etc
In addition to its good-looking appearance, the installation of daytime running light strips can reduce the traffic accident rate by 12.4% and the death rate by 26.4%. This is legal and safe.
  • Suitable for any car model
  • Easy to install without disassembly the headlights
  • Non-flammable fire retardant burn
  • Silicone material with good seal, waterproof , energy saving, anti-corrosion.
  • Daytime running light strips are different from high beam, NO GLARE.


  • Only 4mm thickcan be installed in the gap between the Headlights and the Engine Hood with adhesive tape, no drilling, no screwing and no disassembling needed.

  • Lights are white when turn signal light is off, then the lights flow yellow when turn signal light is switched on.
  • Handpicked SMD-3014 LEDs, no dead light and dark spots, brighter than the stock halogen headlight bulbs. It's a good replacement light for car original headlight.
  • Unlike old designs where the DRL and Turn Signal share the IC Controller, these lights have separate IC Controllers which guarantee stability.
  • Faster on/off response time and vibration resistant
  • Power off during your customizing installation
  • Cut down the strip along the line.
  • Make sure no debris gets in.
  • Sealing the tube with insulated glue after cutting in short.


 Easy Installation, just require right connect to positive and negative side

  • Red wire: Power Positive(+)
  • Black wire: Power Negative(-)/Ground
  • Yellow wire: Left or Right Turn Signal Positive(+)

  • Step 01:Turn on the original headlights(5 screws in total).
  • Step 02:Remove the headlights and clean the sand dust.
  • Step 03:The buckle(near the middle net) first aims at the LED eyebrow then install.
  • Step 04:LED eyebrow threading
  • Step 05:aim at the buckle and install the LED eyebrow
  • Step 06:Tighten 5 screws.
  • Step 07:Connect with the LED eyebrow with the controller socket.
  • Step 08:Pull out the turn light.
  • Step 09:Connect the yellow wire to the positive pole of the turn light(Do not touch the negative pole).
  • Step 10:Connect the red wire to the ACC.
  • Step 11:Connect Black wire to the iron or the screw.
  • Step 12:Finished install the LED eyebrow, then test the effecting.

Universal fit for all 12V/24V auto vehicle, commonly used for Car, SUV, Vans, Truck, RV, Motorcycle, Scooter, Trailer etc.

  • Material: Soft Rubber Tube.
  • Input Voltage: 12V/24V
  • Power Rating: 5.5W
  • Lifespan: 50,000 hours
  • Working Temperature: -40-60 ℃
  • Length: 45cm(17.72in),46cm(18.11in),60cm(23.62in).
  •     1 x LED Strip
  •     1 x Adapter Wire
  •     1 x Instruction Manual
  • Please test the lights to ensure they are working before proceeding with any type of work.
  • Don't stress the cables or bent too much when you try to open the headlight to install them.

You may also like